Then, I tried plugging it into my TV, which is a 40' LG, but EmulationStation refuses to get beyond the. I've spent days updating my Raspbian from Wheezy to Jessie and getting RetroPie installed and working, the whole time using my RPi with my 24' HD BenQ monitor (going through an HDMI->DVI plug) without issue. Hdmi_mode=81 uncomment to force a HDMI mode rather than DVI. I'd like to reopen this old thread, because I'm seeing the exact same issue. Hdmi_force_hotplug=1 uncomment to force a specific HDMI mode (this will force VGA) framebuffer_width=1366 framebuffer_height=768 uncomment if hdmi display is not detected and composite is being output By default it will be display's size minus overscan. If the display is black and the backlight is also off then the FBTFT driver is not installed or loaded correctly. Use positive numbers if console goes off screen, and negative if there is too much border overscan_left=30 overscan_right=15 overscan_top=20 overscan_bottom=10 uncomment to force a console size. The display stays black/white (no output). Hdmi_safe=1 disable_commandline_tags=1 uncomment this if your display has a black border of unused pixels visible and your display can output without overscan disable_overscan=1 hdmi_ignore_edid_=0xa5000080 uncomment the following to adjust overscan. " uncomment if you get no picture on HDMI for a default "safe" mode So, to configure my retropie, i wrote this in /boot/config.txt :
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |